Specifications

Presetting stations in FM modes

There are 10 memory presets for FM radio. They are used in the same way for each operating mode.

Press the Standby button to switch on your radio.

Tune to the required radio station as previously described.

To store the station as a preset, press and hold the required Preset button (1 - 10) until the display

shows 'Preset stored'. The station will be stored under the chosen preset button. Repeat this

procedure as needed for the remaining presets.

Stations which are already stored in the presets may be over written by following the above procedure.

Note:

The radio station presets are retained in memory when the radio is switched off and disconnected

from the mains supply.

Recalling a preset in FM mode

Press the Standby button to switch on your radio.

Select the required operating mode using the Radio button.

Momentarily press the required Preset button. Your radio will then tune to the station stored in

the selected preset memory. The chosen preset number is also shown in the lower area of the

radio display, e.g. 'P2'.

Alternatively, use the Folder Up or Down buttons (on the remote control)

to access FM presets already stored.