User guide
Instructions.
6] You may  also scan the band for SSB  stations by slowly rotating the Rotary  Tuning Knob [31]
        through the selected band,  tuning for  the best intelligibility and watching for  deflections on
        the Signal Strength Indicator  [k] in  the display. (SSB transmit with  a "suppressed carrier"
        meaning the Signal Strength  Indicator [k]  in the display will fluctuate only  when there  is a 
        voice transmission and not  during pauses  in voice transmission.
7] As soon as you have  located a  SSB station (you will  not be  able to understand the speech)
        switch to SSB reception  by depressing  the MODE button [7].  Continued pressing  of the
        MODE button [7] will  alternate between  USB and LSB. Try LSB for frequencies  below 10
        MHz or USB  for frequencies above 10 MHz .
8] After tuning for maximum intelligibility switch MANUAL TUNING/STEP switch [5] to Slow
        position and readjust Rotary  Tuning Knob [31]  for maximum intelligibility.
SWITCH SETTINGS
AM NARROW/WIDE(Switch 33)
For normal operation it is suggested  that this  switch be used in  the wide  position. If occasion arises
where a near-by station interferes with  the station  being listened to the AM Narrow/Wide switch should
be put into the narrow position.
STEREO RECEPTION
The ATS-909 is designed to  receive FM  stereo broadcasts with headphones connected to  the stereo
headphone jack [29]. Switch 33 FM  STEREO/MONO must  be placed in the  stereo position.  Stereo icon
will appear in LCD display if  headphones are  connected.
VOLUME CONTROL
To adjust the volume control [34] to  a comfortable postion. Make sure that  control is  set to 
an adequate level when radio is  set for  waking up.
OPERATING LOCK (BUTTON 9)[ ]
The operating lock prevents unintentional altering of any  of the functions once set or  accidently turning
off the radio. Once  set the  ON/OFF switch and all tuning options  become unalterable and can not be
reactivated until the lock switch is  turned off. It is a good  policy to turn on the lock  switch when
transporting the radio as it will  prevent the  radio from being turned on accidently  while in  a bag or
suitcase. To turn the  lock switch on press switch (9)  [          ]. When the lock  switch is the ON position a  lock
symbol [          ] will  appear in the display. To unlock radio  press switch  (9) [           ] again. This will unlock the
radio and remove the lock symbol  from the  display.
AERIALS
The ATS-909 comes equipped with  a integrated  ferrite antenna built into the radio  that should  provide
more then adequate reception for the  MW and LW bands. For FM  and SW reception it  is advised that
the telescoping antenna be extended and  adjusted in  length and direction for maximum results.
11










