Instruction manual

12
ESC +"c"
[Name] Special character specification
[Code] <1B>H + <634>H or <27>D + <99>D
[Function] F9H to FDH in the character code table are changed as shown in the table
below.
[Operation] This is a toggle operation. Executing ESC + "c" again resumes the original
state. However, this change is performed every one line. In one line, "市"
and "Σ”, or "区" and "μ"、etc. cannot be used. It is not influenced by the CAN
code.
When a character code other than "c" is entered, the instruction is invalid, and data is
printed as is.
Code H9H FAH FBH FCH FDH
Character at initial time
市 区 町 村 人
ESC + "c"
Σ μ Ω π δ
ESC+"R"+n
[Name] International character specification
[Code] <1B>H + <52>H +n or <27>D + <82>D + n
[Function] The international character set is changed. Part of the character code table is
changed with set country characters.
[Operation] Once it is changed, the state is retained until the next command to be
changed is entered. It is also not influenced by the CAN code.
Upon initialization, the character set is JAPAN.
When a character code other than "R" or a numeric value other than n=0H to 6H is
entered, the instruction is invalid. Data is printed in international characters as set
previously.
Country
name
n
Country
name
N
Country
name
n
Country
name
n
JAPAN
FRANCE
0
1
GERMANY
U.K.
2
3
SWEDEN
ITALY
4
5
U.S.A 6
3-4 Character font configuration
The character font is configured as 8 x 6 dots as one unit.
(1) Ordinary character
Almost all of the character patterns are
made of 7 x 5. The illegible character
pattern is 7 x 6.
(2) Double-size enlarged character
The double-size enlarged character is
printed by printing a character
pattern twice.
○○○○○○ ○○○○○○ ○○○○○○○○○○○○
○○●○○○ ●●●○○○ ○○○○●●○○○○○○
○●○●○○ ●○●○○○ ○○●●○○●●○○○○
●○○○●○ ●●●●●● ●●○○○○○○●●○○
●○○○●○ ●○●○●○ ●●○○○○○○●●○○
●●●●●○ ●●●○●○ ●●●●●●●●●●○○
●○○○●○ ○○○○●○ ●●○○○○○○●●○○
●○○○●○ ○○○●●○ ●●○○○○○○●●○○