Instruction manual

3-2-2 Setting correct standing printing and reversed standing printing

After turning power ON during initialization, the printer checks the correct and reverse

standing printing switch on the left side of the circuit board to set correct or reversed

standing printing.

Note: When changing the setting, enter the reset or turn OFF the power supply once.

Neglecting to do this does not change the setting even by changing the switch.

Correct standing printing .............Correct/Reversed standing printing switch Correct

(Right side towards you)

Reversed standing printing ...........Correct/Reversed standing printing switch Reversed

(Left side towards you)

3.3 Control codes

The μTP-58 series provides the following control commands.

Function code Name

Hexadecimal

code

Decimal

code

Reference

page

LF Line feed

<0A> <10> 10

CR Carriage return

<0D> <13> 10

Double-size enlarged

printing mode specification

<0E> <14> 10

Double-size enlarged mode

reset

<0F> <15> 10

CAN Cancel

<18> <24> 10

ESC+”S”+n1+n2+n3+n4 Bit-image graphic

<1B><53> <27><83> 11

ESC+”c”

Special character

specification

<1B><63> <27><99> 12

ESC+”R”+n

International character

specification

<1B><52> <27><82> 12

Printer

Reversed standing printing Correct standing printing

Paper feeding

direction