Instruction manual

7
(3) Pull out roll paper to this side and turn on the power supply. While pressing the FEED
switch, insert the tip of roll paper with it straight so that it can be set horizontally with the
wall surface of the sheet insertion slot.
Note: If paper is bent, it may cause jams.
If roll paper is not engaged with the roller, no paper is fed. Insert paper deep enough
to reach the roller.
Continuously press the FEED switch until roll paper comes out from the printer head section.
(4) Place the tip of roll paper that has come out on the outer side of the sheet cutting outlet of
the panel and set the inner case and panel in the case.
FEED switch
Printer head
Inner case
Main body case
Roll paper fixing shaft
Roll paper
Sheet insertion slot
Printing surface
Roller