Specifications

２２
SK1-21/31
2- 11．Handling Bezel
Bezel has two modes shown as below:
Setting Bezel mode is to refer to the subject on memory switch.
。
Bezel Mode Functions
Bezel Mode A/B In case paper does not feed 60mm when power is on or after
auto-cutting, paper feeds automatically until it is fed to 60mm.
Bezel Mode A Detection by Bezel sensor is transmitted by ESC v or GS a
command. Such as suspension of printing is not done by Bezel
sensor detection.
Bezel Mode B After auto-cutting paper, the next-transmitted data is deleted while
paper is in the bezel.
Bezel sensor detection is recommended by status command ESC
v , GS R1 or GS a.
・Bezel Setting
Bezel