Owner's manual

78
4
.
T
rou
bl
es
h
oot
i
n
g
–
Th
rea
d
turn
i
n
g
Abnormal  ank wear
Vibration
Poor surface on one
 ank of thread.
• Incorrect method for  ank infeed
• Insert inclination angle does not
agree with the lead angle of the
thread
• Incorrect workpiece clamping
• Incorrect tool set-up
• Incorrect cutting data
• Incorrect centre height
• Change method of  ank infeed for F-
and A-geometry to 3 - 5° from  ank.
For C-geometry to 1° from  ank
• Change shim to obtain correct angle
of inclination
• Use soft jaws
• Optimize centre hole and check
pressure of face driver
Minimize overhang of tool
Check that the clamping sleeve for
bars is not worn
Use 4C anti-vibration bars
• Increase cutting speed; if this does
not help, lower the speed dramati-
cally. Try F-geometry
• Adjust to correct centre height
• Use solid carbide shanks
Problem Cause Solution