users guide User guide

33
Internal grooving and profiling
Reduce risk of vibration:
Set-up should have the shortest possible overhang
with the lightest cutting geometry possible.
Use a smaller insert and make several cuts instead
of one.
Start from outside and make overlapping cuts inwards
for best chip evacuation.
A finishing operation can be a side turning motion.
Start from inside and turn outwards.
Ramping/turning can be used for improved chip
control and may reduce vibration.
Use right- or left-hand style inserts to direct the chips
when roughing.
Machine large-width
grooves using several
insertions with a
narrower insert
(illustration A).
End with a finishing cut
(illustration B).