Manual

3. Turning

Tips and hints, summary

Reduce the risk of vibration by choosing the largest possible bar

diameter with the smallest possible overhang. Use recommended

clamping length, minimum 4 x BD.

Cut off of the CR boring bars above 10 x BD

is not allowed. For

570-4C bars, clamping over the dampening mechanism is allowed,

while it is not allowed for 3C bars. When a 570-3C short design bar

is cut-off to minimum length, the clamping length must not exceed

3 x BD to avoid clamping over the dampening mechanism. Never

cut-off 570-3C bars diameter >100mm (3.94 inch).