s Instruction Manual

Master Gauge

• Cx-MAS-01 Toqualifythedatumpositiononallclampingunits

and pre-measuring units

• Cx-MAS-11 Forclampingunitalignment–importantfordrilling

Cx-MAS-01

Cx-MAS-11

Pre-measuring fixture

For pre-measuring close to the machine a xture block with

dial indicator can be used. When the pre-measured unit is

returned to the clamping unit in the turret, the edge deviation

is compensated through the machine control offset.

The master gauge is used to dene the same ‘zero’ position

for clamping units and measuring xture.