users guide Instruction Manual

ManualsBrandsSandvik Coromant ManualsMetalworkingParting and grooving

77

Cause

Excessive temperature in cut-•

ting zone.

Unsuitable grade.•

Lack of coolant supply.•

Solution

Reduce cutting speed and/or •

feed.

Choose more wear resistant •

grade.

Improve coolant supply.•

Plastic deformation (PD)

Cause

Cutting speed too high.•

Too soft grade.•

Lack of coolant supply.•

Solution

Decrease cutting speed.•

Choose more wear resistant •

grade.

Improve coolant supply.•

Flank wear

Cause

Cutting speed too high.•

Too soft grade.•

Feed too high.•

Lack of coo• lant supply.

Solution

Decrease cutting speed.•

Choose more wear resistant •

grade.

Decrease feed.•

Improve coolant supply.•

Crater wear

Cause

Oxidation at the cutting depth.•

Too high edge temperature.•

Solution

Use varying cutting depths.•

Reduce cutting speed.•

Notch wear