Owner's manual

Machining strategies
CFRP•
- Quality must be checked both at hole entry and exit: different cutting
conditions may be needed.
- Quality at exit is usually more difcult to achieve due to cutting forces.
Stacked materials•
- Cutting speed on a stacked metallic material, such as titanium, usually
needs to be lower than the CFRP.
- The best cutting condition, for the metallic material, may be too slow
for good productivity on the composite material. Therefore variable cutting
data can be favourable.
feed rate: 0.15
2 mm
feed rate: 0.05
10
10
10
- Entry layer
- Mid layer
- Exit layer
Application example =
Entry layer : CFRP
Mid layer : Al or Ti
Exit layer : CFRP
SANDVIK COROMANT USER’S GUIDE - COMPOSITE SOLUTIONS 29