Instruction manual
GB-14
6. Connecting to the Mains Supply
Insert the mains plug into a wall socket. Your system is now ready to use.
ECO-Power/Standby Features
This unit features an ECO-Power/Standby mode. Press the ON/STANDBY button on
the remote control or on the unit to enter standby mode. To save energy consumption,
the clock will not be displayed.
If you want to display the clock during standby mode, you can press the CLOCK
button on the remote control. The clock display will disappear after 90 seconds.
Setting the Clock
Setting the Clock Manually
1. Set the unit to Standby mode.
2. Press the CLOCK button on the remote control twice, “CLOCK 12HR” will show and
“12” will blink. Set the clock to 12 or 24 hours format with the VOL+/– buttons.
Press the CLOCK button again, the hour indicator will blink.
3. Set the hour with the VOL +/– buttons.
4. Press the CLOCK button again, the minute indicator will blink.
5. Set the minute with VOL +/– buttons.
6. Press the CLOCK button, the built-in clock starts operating.
The Amplier
The CD Player
Be sure to unplug the mains plug from the mains socket when going out
or when the system is not in use for an extended period of time.
• The clock can only be set while in Standby mode. You must press the setting
buttons before 30 seconds elapses or the setup will be cancelled.
• If a power failure occurs or the unit is disconnected from the mains, the clock
setting will be lost.
SHFTPPH10_IB_final101208.indd 14 12/8/10 2:10 PM