Manual
mps03dl3sm-rev1110 Model MPS03 Page 1
MARATHON
®
•WarrenRupp,Inc.•AUnitofIDEXCorporation•800N.MainSt.,Manseld,Ohio44902USA
Telephone(419)524-8388•Fax(419)522-7867•www.warrenrupp.com
OPERATING INSTRUCTIONS
THE PUMP:Thispumpisatotallyenclosed, submersibledewateringunit.Itis
powered bya1/3HP,12voltDC30AMPmotor.Batteryclipsonthepowercordallow
easyconnectiontoany12voltvehiclebattery.
SWITCHING:Theon-offswitchislocatedonthepowercord.
CONNECTING TO BATTERY:Whenconnectingtheclipstoabattery,arcingis
eliminatedbykeepingtheon-offswitchinthe“off”position.Connecttheredbattery
clamptothepositive(+)batteryterminal.Connecttheblackbatteryclamptoground:
preferablyonthevehicle’senginetoasolid,metallic,stationarypoint.Theconnection
shouldbeatleast18inches(480mm)fromthebattery.
IMPORTANT SAFETY
INFORMATION
Turnoffbeforeconnectingbattery
clampstobattery.Arcingcouldresult.
DANGER
IMPORTANT
Read these safety warnings
and instr u ctions in t h is
manual completely, before
installation and start-up of the pump. It
is the responsibility of the purchaser to
retain this manual for reference. Failure to
comply with the recommendations stated
in this manual will damage the pump, and
void factory warranty.
HOSE:Sincethepumpdevelopsrelativelylowpressure,itisrecommendedthat
non-collapsiblehosebeusedformaximumpumpingrates.
HOISTING & LOWERING:Attachalinetothemetalhandleonthetopofthe
pumpforhoistingorloweringtheunit.Donot use power cable for handling unit.
TO OPERATE: Lowerunitintoliquidtobepumpedandactivateswitch.Pump
canberunforafewminuteswithoutliquid,however,do not run completely dry for
extended periods. Damagetoshaftsealmayresult.
RUNNING TIME: This unit draws about 30 amperes and can be operated
about 1hour on a fully charged 55AMP-hour battery and still permit starting of
vehicle under normal conditions. Caution should be used when running time
exceeds 30 or 40 minutes without engine running to recharge battery, particularly
in cold weather when battery efciency is lowered. Battery size (AMP-hour rating)
andtheuseofotheraccessoriessuchaslightsandradios,etc.,mustbetakeninto
considerationforpracticalrunningperiodswithoutenginerunning.
OVERLOAD PROTECTION isprovidedbymeansofa40ampautomaticreset
circuitbreaker,locatedundertopcover.
1. M ake sur e th e ve hic le a nd t he
pump are not in contact during
connection.
2. Do not use power cable for handling
unit.
3. Do not run completely dry for
extended periods. Damage to shaft
seal may result.
DANGER
DANGER: Not for use with
fluids that have a flash point
below 100° F (38° C) [examples:
gasoline, alcohol.] Sparking could result
in death.
Handi-Pump
Model MPS03
SERVICE & OPERATING MANUAL
Original Instructions





