Owner manual

dmf2dl5sm-rev0614 Model DMF2 Page 2
Meanings of
Abbreviations:
AL = Aluminum DC = Die Cast SS = Stainless Steel
B = Nitrile PS = Plated Steel
Explanation of Pump Nomenclature: DMF2R & DMF2S
II 2GD T5
II 2 G c T5
II 3/2 G c T5
II 2 D c T100oC
All models, including pumps equipped with Aluminum wetted and midsection parts.
See page 21 for ATEX Explanation of Type Examination Certicate.
DMF2
Type 5
Manifold
Elbow
Outer
Chamber
Inner
Chamber
Outer
Diaphragm
plates
Inner
Diaphragm
Plate
Intermediate
Housing
Diaphragm
Rod
Valve
Seat
Hardware Diaphragm Flap
Valve
Material
Seat
Gasket
Sealing
Rings
Shippping
Wt. (lbs)
DB-5-A AL380DC AL380DC AL380DC PS PS 356-T6AL 435SS 316SS PS B B N/A B 86
MATERIALS OF CONSTRUCTION
To order a pump or replacement parts, rst enter the Model Number DMF2R, or DMF2S, followed by the Type Designation listed below in the far left column.
Materials
Operating Temperatures
For specic applications, always consult “Chemical Resistance Chart" Technical Bulletin
Nitrile General purpose, oil-resistant. Shows good solvent, oil, water and hydraulic uid resistance. Should
not be used with highly polar solvents like acetone and MEK, ozone, chlorinated hydrocarbons and nitro
hydrocarbons.
Maximum Minimum
190°F -10°F
88°C -23°C
Maximum and Minimum Temperatures are the limits for which
these materials can be operated. Temperatures coupled with
pressure affect the longevity of diaphragm pump components.
Maximum life should not be expected at the extreme limits of
the temperature ranges.