User guide

Boot Setup CP6016 uEFI BIOS
Page 42 ID 1022-7205, Rev. 2.0
P R E L I M I N A R Y
5.1.2 Setup Prompt Timeout
This integer function is used to set an additional time the POST should wait for the operator to
press the key to enter setup. The time is entered in seconds.
Default setting: 1
5.1.3 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: On
5.1.4 Option ROM Messages
This function is used to control the messages of the loaded PCI option ROMs.
Default setting: Force BIOS
5.1.5 Interrupt 19 Capture
This function is used to specify if legacy PCI option ROMs are allowed to capture software in-
terrupt 19h.
Default setting: Disabled
SETTING DESCRIPTION
1
.
.
.
65535
Use one of these settings to specify the setup prompt timeout.
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.
SETTING DESCRIPTION
Force BIOS Use this setting to force to a BIOS-compatible output. This will show the option ROM mes-
sages.
Keep Current Use this setting to keep the current video mode. This will suppress option ROM messages.
Option ROMs requiring interactive inputs may not work properly in this mode.
SETTING DESCRIPTION
Disabled Use this setting to prevent legacy PCI option ROMs from capturing software interrupt 19h.
Enabled Use this setting to allow legacy PCI option ROMs to capture software interrupt 19h.