User guide

Boot Setup AM5030 uEFI BIOS
Page 34 ID 1037-1209, Rev. 1.0
P R E L I M I N A R Y
5.1.2 Fast Boot
This function is used to enable or disable boot with initialization of a minimal set of devices re-
quired to launch active boot option..
Default setting: Disabled
5.1.3 Setup Prompt Timeout
This integer function is used to set an additional time the POST should wait for the operator to
press the key to enter setup. The time is entered in seconds.
Default setting: 1
5.1.4 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: On
5.1.5 CSM16 Module Version
This function provides display-only information concerning the CSM Module and is intended for
internal use only.
5.1.6 GateA20 Active
This function is used to enable or disable GateA20.
Default setting: Upon Request
SETTING DESCRIPTION
Disabled Use this setting to disable fast boot.
Enabled Use this setting to enable fast boot.
SETTING DESCRIPTION
1
.
.
.
65535
Use one of these settings to specify the setup prompt timeout.
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.
SETTING DESCRIPTION
Upon Request Use this setting to disable GA20 in the uEFI BIOS.
Always Use this setting to prevent the system from disabling GA20.