Instruction manual
SandenHeatPump–InstallationManual
Page24of26
9. Repair and/or replacement of the Heat Pump Water Heater System due to scale formation
in the waterways or the effects of either corrosive water or water with a high chloride or
low pH level when the water heater has been connected to a scaling or corrosive water
supply or a water supply with a high chloride or low pH level as outlined in the Owner's
Guide and Installation Manual.
Subject to any statutory provisions to the contrary, this warranty excludes any and all claims
for damage to furniture, carpets, walls, foundations or any other consequential loss either
directly or indirectly due to leakage from the Heat Pump Water Heater System, or due to
leakage from fittings and/or pipe work of metal, plastic or other materials caused by water
temperature, workmanship or other modes of failure.
WarrantyPeriod
Subject to the Warranty Conditions and Exclusions stated above, your Sanden Heat Pump Water
Heater System is warranted as follows:
Heat pump unit – Five years from date of installation
Tank unit – Ten years from date of installation
Postinstallationinspectionchecklist
On completion of the installation, inspect and check off each item in the charts on the
following page once the inspection has been completed remove the inspection table and
hand to the customer.