CARE AND MAINTENANCE Spot clean using a mild water-fees solvent. Only a professional cleaner should undertake a complete overall cleaning. The use of steam or water-based cleanses may cause excessive shrinking or staining, NOTICE * Please make sure that you have all parts indicated before you begin assembly of this fem, * This fem should be assembled on a soft surface fo prevent scratching the finish during assembly. * This tern may require periodic Tightening.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and bard wars contents list, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver STEP 1 ATTACH CAM BOLTS TO TOR PANEL, LEFT AND RIGHT PANELS, BOTTOM PANEL AND SIDE BACK PANELS, STEP 2 ATTACH BIO BACK PANELS TO CENTER BACK PANEL USING HEMLOCKS.
PREPARATION Before beginning assembly of product, make sure all parts are present, Compare parts with package contents list and hardware contents lst, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver STEP 3 ATTACH LEFT PANEL TO UNIT USING CAM LOCKS. STEP 4 ATTACH FRAMES TL UNIT USING CATALOGS.
PREPARATION Before beginning assembly of product, make sure all parts are present, Compare parts with package contents list and hardware contents lst, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver BYES 5 ATTACH RIGHT PANEL TO UNIT TUBING CAMELLIAS, STEP 8 ATTACH TOP AND BOTTOM PANELS TO UNIT USING CAM LOCKS AND WOOTEN DOWEL,
PREPARATION Before beginning assembly of product, make sure all parts are present, Compare parts with package contents list and hardware contents lst, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver STEP 7 ATTACH LEGS TO UNIT USING BOLTS, SPRING WASHERS AND FLAT WASHERS, TIGHTEN [STEP 8 ADJUST THE ADJUSTER THAT HAS ALREADY BEEN ASSEMBLED TO THE LEGS TO BOLTS USING ALLEN KEY, STABILIZE YOUR UNIT,
PREPARATION Before beginning assembly of product, make sure all parts are present.
PREPARATION Before beginning assembly of product, make sure all parts are present, Compare parts with package contents list and hardware contents lst, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver STEP 41 LOOSEN SLIGHTLY THE SCREWS PER-INSTALLED ON THE BACK OF THE UPPER AND STEP 12 INSERT THE DRAWER INTO THE UNIT, THEN ADJUST THE DRAWER FRONT PANEL LEFT LOWER DRAWER FRONTS, OR RIGHT AND UP OR
PREPARATION Before beginning assembly of product, make sure all parts are present, Compare parts with package contents list and hardware contents lst, if any part is missing or damaged, do not attempt to assemble the product, Estimated Assembly Tine 80 minutes, Tools Required for Assembly © Phillips Screwdriver STEP 43 FULL THE DRAWER OPEN BLOWY AND RE-TIGHTEN THE SCREWS FROM STEP 11, BAKE SURE THE FRONT PANEL DOES NOT MOVE AND LOCK THE DRAWER FRONT PANEL INT [STEP 14 SLIDE THE DRAWERS INTO UNIT.
