Installation & Assembly

3LT PENDANT LIGHT

ASSEMBLY/INSTALLATION INSTRUCTIONS

installation.

shock.

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

referencing the illustrations on the installation instructions.

Phillips screwdriver.

CAUTION

GENERAL

TOOLS REQUIRED

ASSEMBLY AND INSTALLATION

(CONT.)

Turn off the power at fuse or circuit breaker.

Turn on the power at fuse or circuit breaker.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

1. Attach the NIPPLE to the CROSS BAR, then secure it with a WASHER and HEX NUT.

2. Attach the CROSS BAR to the JUNCTION BOX by using two JUNCTION BOX SCREWS.

3. Secure the TOP LOOP to the NIPPLE.

7.Choose the length of the CHAIN you need, then weave the FIXTURE WIRE and the FIXTURE GROUND

10. Pull out the SUPPLY WIRES and SUPPLY GROUND WIRE from the JUNCTION BOX. Make wire

connections using the WIRE CONNECTORS:

---Attach the FIXTURE GROUND WIRE to the CROSS BAR with the GREEN GROUND SCREW.

Then connect it to the SUPPLY GROUND WIRE with a WIRE CONNECTOR.

Carefully put the wires back into the JUNCTION BOX.

Please read carefully and save these instructions, as you may need them at a later date.

WIRE through the CHAIN, COLLAR and CEILING PLATE.

8. Open the top and bottom section of the CHAIN using a phillips screwdriver (not included) and pliers

(not included), then attach it to the LOOP. Close the CHAIN.

9. Thread the FIXTURE WIRE and FIXTURE GROUND WIRE through the TOP LOOP, NIPPLE and

CROSS BAR.

11. Attach the CEILING PLATE to the CROSS BAR by inserting the TOP LOOP, then secure it with the COLLAR.

13. Install BULBS(not included). See relamping label at socket area or packaging for maximum allowed wattage.

6. Tighten the STEM and FIXTURE FINIAL into the FIXTURE.

4. Attach the IRON RING and ORNAMNT onto FIXTURE using BALL NUTS.

12. Attach the GLASS onto SOCKET using SOCKET RINGS.

PAGE 1
3LT PENDANT LIGHT ASSEMBLY/INSTALLATION INSTRUCTIONS ASSEMBLY AND INSTALLATION (CONT.) Please read carefully and save these instructions, as you may need them at a later date. CAUTION installation. shock. GENERAL All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a referencing the illustrations on the installation instructions. Phillips screwdriver.