Owner Manual

Rafter 36” Bathroom Vanity

Page 2 of 4

STEP 1

• Place the vanity in the desired location.

• Ensure the vanity is level. Shim legs, if necessary.

• The drawers need to be removed to assist with plumbing installation and to secure the vanity to the wall. Locate

the plastic clips located on both sides of the bottom of the drawer. At the same time, press the right spring clip

downward and the left spring clip upward. Once both spring clips are held in the indicated position, pull the

drawer straight out.

• Install the faucet and all plumbing.

• Using the appropriate screws and wall anchors secure the vanity to the wall through the back rail panel of the

vanity.

Before installation, please check received items in below “Part List”. Please report any missing items to your

retailer immediately.

Part List

Part A - Vanity w/top 1 PC

Part B - Backsplash 1PC

• Ensure there are no water leaks.

• To reinsert the drawers, close completely both

drawer slides attached to the vanity. Move the

component of the slides with ball bearings to the

front of the slides, maintaining the slides completely

closed. Carefully line up the slides of the drawer box

with the slides in the base cabinet and close the

drawer all the way to the back. Open the drawer

completely to ensure it is properly installed.

Part C - Door

Part D - Hardware 2PCS

NOTES, ASSEMBLY AND INSTALLATION

● Faucet, drain, silicone and all other plumbing components, tools & hardware are not included.

● Handling will require two people.

● Ensure the vanity is installed on a level floor. Unevenness can cause the vanity to become misaligned,

resulting in twisting of the cabinet. Repair any uneven areas with shims.

● Ensure all building & plumbing codes are respected. Professional installation recommended.