Full Product Manual

7.
Locate the remaining spokes
inside of the safe. Insert each
individual spoke into a
threaded opening and turn
clockwise to install.
Note: The SA-PLAT1-BIO model
only requires a single spoke. No
addional spokes will need
installed for that specific model.
6.
Step 6
WARNING: The baeries must be inserted with the correct polarity. Exhausted baeries
must be removed from the product and discarded safely. Do not mix old and new baeries.
Do not mix alkaline or standard (carbon – zinc) baeries. Do not use rechargeable (nickel –
cadmium) baeries.
6
3. INITIAL ENTRY (Continued)
Locate the 4xAA baeries.
Install them into the baery
compartment on top of the
door panel in the proper
orientaon. The unit will
beep when baeries are
successfully installed.
Replace baery cover.
Step 7
TO REMOVE
TO ATTACH
5.
Locate the magnec key
cover inside of your safe.
On the front of the safe,
remove the backup key
and install the magnec
key cover in this same
locaon as shown.
If the backup key is
required in the future, the
magnec key cover can
then be removed by
pressing down on the le
or right side of the
branded plate. The cover
will then pop up on the
opposite side, so it can be
removed.
Step 5