Full Product Manual
15
13. SILENT ENTRY MODE
1.
To maximize burglary protecon and stability, securing the safe to the floor or
wall is recommended.
2.
3. Always ensure the safe is in an isolated and dry area. Never place the safe in
direct contact with a wet floor. When installing your safe on a concrete floor,
use of a moisture/protecve barrier is highly recommended. Failure to do so,
or exposing the safe to chemicals or other adverse environments, may void
the warranty.
SA Consumer Products recommends that you store your safe in a closet, office,
basement, bedroom or any other locao
n that is convenient for you but out of
direct line of sight from prying eyes.
14. PROPER PLACEMENT AND MOVING OF SAFE
15. KEEPING YOUR SAFE DRY
We recommend placing a moisture/protecve barrier between your safe and
concrete floor to prevent any moisture, mildew and rust damage the safe. Installing
your safe in a place with climate control (heat in the winter and cooling in the summer)
is highly recommended. In areas of high humidity or frequent temperature fluctuaons
(garages) it is recommend to take appropriate precauons to ward against moisture
damage. We strongly encourage the use of an internal dehumidifier and/or desiccants
to protect your contents from rust or mildew. Internal dehumidifiers should not be
in direct contact with the side or back walls.
By acvang the silent entry mode, the safe will
no longer make audible sounds.
To turn on silent entry mode, hold a programmed
finger on the scanner for 5 seconds beyond your
fingerprint being accepted. The green indicator
ring will turn off and back on, but will not beep,
indicang you are now in silent entry mode.
You will not hear any sounds for any funcons
while the safe is in silent entry mode.
To turn the sound back on, hold a programmed
finger on the scanner for 5 seconds beyond your
fingerprint being accepted. The green indicator
ring will turn off and back on and will beep once
indicang you are no longer in silent entry mode.