Full Product Manual

14
12. LOCKOUT MODE / TAMPER PROTECTION
11. LOW BATTERY WARNING
10. INTERNAL LIGHTING
When the safe door is opened,
internal lighng acvates for 30
seconds.
If you need to acvate your light
longer, you can press the green light
acvaon buon on the inner door
panel. This will acvate the internal
lighng for an addional 30 seconds
each me it is pressed.
1.
Three consecuve rejected scans put the safe
in “Basic Lockout” mode. The Bio Scanner is
deacvated for 30 seconds.
2.
Six consecuve rejected scans result in
“Severe Lockout” mode. The Bio Scanner is
deacvated for 5 minutes.
3.
Aer the safe enters basic or severe lockout mode, the tamper indicator will
trigger to warn you that someone has unsuccessfully aempted to gain access to
your safe. This tamper indicator will signal immediately aer the next successful
fingerprint is accepted. The indicator ring will flash red 3 mes in addion to a 3
second long beep.
This safe is equipped to alert you of Low
Baery Mode. This Low Baery Warning is
iniated immediately aer an accepted
fingerprint scan. The indicator ring will first
illuminate green followed by a 3 second long
beep and the indicator ring flashing purple for
3 seconds. It is highly advised to immediately
replace the safe's baeries to avoid being
locked out of your safe.
BATTERIES ARE LOW
IF THE INDICATOR RING
FLASHES PURPLE
Note: During lockout mode, the indicator ring will
light up red once every 10 seconds. When lockout
mode has ended, the indicator ring will flash green
1 me and you will hear 1 beep . You now have access
to your bio scanner.
Internal Light
Light
Acvaon Buon