Instruction Manual

7
➜ After setting the mode to ➜ Rotate the channel
dial to select the desired channel.
1-3-2 FREQUENCY INPUT
➜ ➜ After setting the mode ➜ Rotate the channel
dial to move to the channel, in which there is no input of frequency ➜ Repeatedly press
on the front panel of keyboard and select [TX]. ➜ Press KEY to input
desired frequency.
[Ref.] If frequency is out of range, frequency cannot be input with ‘beep’ alarm sound.
[Ref.] Press the button , put on [TX] and if you press , you can change the
frequency with the dial from 10Hz to 10MHz by selecting it with the buttons ,
.
[Ref.] In CH1~ CH32 there is no frequency change and it applies from CH33 ~ to CH40.
1-3-3 CALL
➜ ➜ TO : --------- ➜ ➜ DIRECT INPUT ➜
➜ Input the other party's MMSI ➜ ➜ Frequency selection ➜
➜ MODE selection ➜ ➜ COMM Frequency selection ➜
Press .
1-3-4 DSC MESSAGE RX AUTO REPLY
➜ ➜ mode selection ➜
➜ [1. DSC SETUP] ➜ ➜ [4.AUTO ACK SET] ➜
1. AUTO ACK TEST: ON , 2. AUTO ACK POLLING : ON ,
3. AUTO POSITION: OFF , 4 . AUTO ACK INDIVIDUAL: ON