Instruction Manual

9-2 JP-3750 PRINTER

1) Normal operation

① Make sure that the power of the SRG-150DN / 250DN main unit connected to this

unit is turned on

② Turn on the POWER switch and turn on the power

③ It automatically enters the DSC MESSAGE and DATA of the transmission and

reception sent from the SRG-150DN / 250DN.

2) How to install and use ROLL paper

① Open the cover

② Put the ROLL paper holder in the holes on both sides of the printer

③ Insert the ROLL paper support cap into the socket on the back of the printer.

④ Move the handle lever toward the front side so that the column indicator comes off

the platen.

⑤ Position the paper release lever at the front position.

⑥ Put the paper rod on the ROLL paper core, and open the guide of the ROLL paper

support.

⑦ Insert the paper from the back of the platen over the paper barrel, and check that the

end of the paper lies on the end of the platen.

⑧ Lightly push the paper, close the paper release lever, and turn the platen handle so

that the paper is in front of the platen.

⑨ Close the handle lever.

⑩ Place the cover in place.