Instruction Manual

77
④ Paper exit
The exit of PRINTER paper.
⑤ PAPER COVER (Paper storage part)
In this cover, the printer paper is stored.
3) Normal operation
- Check that the power of the SRG-150DN / 250DN main unit connected to this unit is
turned on.
- Turn the POWER switch up to turn on the power
- This automatically puts the DSC MESSAGE and DATA of the transmission and reception
sent from the SRG-150DN / 250DN into operation.
4) How to install PRINTER paper
① PRINTER Cut the end of the paper at right angles.
If paper is inserted in a wrinkled state, paper clogging may occur.
How to use PRINTER paper
② Set the POWER switch on the PRINTER to OFF.
③ Open the cover and remove the cover shaft.
④ Insert the CENTER SHAFT into the center of the paper, and push the end of the paper
into the paper insertion slot.
⑤ Insert the POWER switch, then press the FEED switch repeatedly until the paper is
sucked in.
⑥ When the paper is sucked in, hold the CENTER SHAFT in the holder.
⑦ Keep pressing the FEED switch until the end of the paper is coming out.
⑧ Close the Paper cover and press the top of the cover until it locks.