User's Guide

Installation
9
The MP9320 is factory calibrated for operation with the
following type of antenna and cable:
It is highly recommended that the antenna mounting be adjustable
in order to obtain the best performance from the system.
However, the antennas must be installed on a solid surface or
frame to prevent damage or later misalignment. Perform the
following to install the antennas.
NOTE: Use the existing mounting holes on the antenna flange. Drilling
new holes in the flange is not recommended.
1. Determine the location of each antenna. Ensure the
antenna(s) will not be vulnerable to damage by moving
inventory or equipment.
2. Use the antenna as a template and mark the mounting holes.
3. Drill and tap (if necessary) mounting holes for #10 or 1/4
inch mounting screws. For drywall mounting, use drywall
anchors or toggle screws.
Antenna Parameter FCC ETSI
Frequency 902-928 MHz 865-870 MHz
Polarization Circular Circular
Gain, dBic 8, max 8, max
Power, minimum 1 W 1 W
VSWR, maximum 1.5:1 1.5:1
Cable Parameter Value
Type RG58C/U
Length 2 Meters
Connector SMA type plug, reader side