Owner`s manual

MPEG2 sound
You can enjoy motion picture and live concert DVD video discs with dynamic realistic sound by connecting an amplifier
equipped with an MPEG2 audio decoder or MPEG2 audio processor.
A rMP/if_i&2e2ui2°P_dew_tel ra_ _ _ _
To COAXIAL I l
type digital To COAXIAL DIGITAL
audio input AUDIO OUT
75 _2coaxial cable (not supplied)
t--
• Use DVD video discs
encoded via the
Dolby Digital
recording system.
o
O
¢#
&
O
÷
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an amplifier equipped with a digital audio input
and speaker system (right and left front speakers).
Amplifier equipped with a1
Digital audio input |
[_ To COAXIAL I l
type digital To COAXIAL DIGITAL
audio input AUDIO OUT
75 _ coaxial cable (not supplied)
÷
Notes:
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the unit to the AC-3 RF input of a Dolby Digital Receiver.
This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO
OUT jack of the unit.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the unit to the "COAXIAU' input of a Receiver or Processor.
• Refer to the owner's manual of the connected equipment as well.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections.
• The output sound of the unit has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening
level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the unit's power cord. If you leave the amplifier's power oil, the
speakers may be damaged.
17
5V60101A [E]p13-18 17 _ 2/22/06, 1:03 PM