Owner's manual

English
English50
Troubleshooting
Checkpoints
If you encounter a problem with the washer, first check the table below and try the suggestions.
Problem Action
Does not start.
• Make sure the washer is plugged in.
• Make sure the door is properly closed.
• Make sure the faucets are open.
• Make sure to press or tap Start/Pause (Hold to Start) to start the washer.
• Make sure Child Lock is not activated.
• Before the washer starts to fill, it will make a series of clicking noises to
check the door lock and does a quick drain.
• Check the fuse or reset the circuit breaker.
Water supply is
insufficient, or no water
is supplied.
• Fully open the faucet.
• Make sure the door is properly closed.
• Make sure the water supply hose is not frozen.
• Make sure the water supply hose is not kinked or clogged.
• Make sure there is sufficient water pressure (20-116 PSI).
• Make sure the hoses are connected to the correct taps. Flush water lines.
• Disconnect the hoses and clean the mesh filters. The mesh filters may be
clogged.
After a cycle, detergent
remains in the detergent
drawer.
• Make sure the washer is running with sufficient water pressure (20-116
PSI).
• Make sure you add liquid detergent to the liquid detergent container.
Make sure to remove the liquid detergent container if you are using
powdered detergent.
• Clean the detergent drawer.
Untitled-5 50 2022-01-20  5:06:28