Specifications

INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your Washer.
Unbalanced load prevented your
Washer from spinning.
Door is unlocked when Washer is
running.
Door is open when Washer is
running.
Redistribute the load, press the Start/Pause
Button.
Press the Power button to turn off your Washer,
then restart the cycle. If the code reappears, call
for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
FL i ourWasherfai,edto,ockthe
door.
Water temperature control
problem.
(Heater Control problem)
hE YourhasnotWasherreachedhasthetriedproperto fill butwater
level.
U-J
The door will not unlock.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer,
Motor not running properly.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
then turn it on again. If the code reappears, call
for service.
Restart the cycle pressing the Start/Pause
Button. If the code reappears, call for service.
Before calling for service, check the following.
1, Clean the filter. (see page 19)
or
1.
Your Washer has tried to fill but
was unsuccessful.
Problem with control.
Electric service was lost when Restart the cycle by pressing the Start/Pause
Washer was running. Button.
t-IF A fault is detected in the water Call for service
I,_IC level sensor.
Jammed Key. Call for service
Turn off the unit for 10 seconds and then turn
it on again.
2, Select only the Spin Cycle.
3, Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
Call for service.
Troub eshooting 23
WF338AA-02562A-01 EN.indd 23 2008-03-10 ;_2_L2_3:35:54