Service manual

Troubleshooting
5-2
INVALID
CARTRIDGE
You have used unauthorised cartridge. You must use a Samsung approved car-
tridge.
LINE BUSY The remote FAX didn’t answer Try again.
LOAD DOCUMENT You have attempted to set up a sending opera-
tion with no document loaded.
Load a document and try again.
MEMORY FULL The memory has become full. Either delete unnecessary documents, or
retransmit after more memory becomes
available, or split the transmission into
more than one operation.
NO ANSWER The remote machine was not answered after all
the redial attempts.
Try again.
Make sure the remote machine is OK.
NO DEVELOPER
CARTRIDGE
When the machine detected the toner cartridge
has not been installed.
Install the Cartridge.
NO. NOT ASSIGNED The speed dial location you tried to use has no
number assigned to it.
Dial the number manually with the key-
pad, or assign the number.
[NO PAPER]
ADD PAPER
The recording paper has run out. The printer sys-
tem stops.
Load the recording paper in the paper
feeder.
[PAPER JAM 0]
OPEN/CLOSE DOOR
Recording paper has jammed in paper feeding
area.
Recording paper is jammed in pick-up unit
Press STOP and clear the jam.
[PAPER JAM 1]
OPEN/CLOSE DOOR
Recording paper has jammed inside the unit.
Recording paper has jammed in paper exit unit.
Clear the jam.
[PAPER JAM 2]
CHECK INSIDE
Paper has jammed in the paper exit area.
[TONER EMPTY] When the machine has encountered the Toner
Empty.
Replace the Toner Cartridge.
[TONER LOW] The toner is almost empty. Take out the toner cartridge and gently
shake it. By doing this, you can tempo-
rarily re-establish printing operations.
REPLACE DRUM When the machine has encountered the out of
from lifr, 15000 print pages.
Replace the Drum Cartridge.
RETRY REDIAL? The machine is waiting for the programmed inter-
val to automatically redial.
You can press START to immediately
redial, or STOP to cancel the redial
operation.
OPEN HEAT EROR Thermister does not connected to main board or
contact point is not coupled tightly in power on.
Check thermister contact point, Heating
Camp & Thermostat.
[OVERHEAT] The printer part has overheated. Your unit will automatically return to the
standby mode when it cools down to nor-
mal operating temperature. If failure per-
sists, call service.
SCANNER LOCKED Scanner is locked by locker. Check locker.
Connect the Flat-Cable.
ERROR MESSAGE DESCRIPTION SOLUTION