Specifications

OWNER’S GUIDE  DEWE3210 | 597
Turning on the System
Locate the power switch on the front panel above
the main screen. This is a momentary rocker type
switch, where the white dot indicates the ON direc-
tion.
♦ Press ON and hold for one second to power the
system on.
♦ Press ON and hold for 3 seconds to power OFF.
♦ Green POWER LED: lit when the system is
powered on
- The LCD battery display is ALWAYS on when any bat-
teries are installed. This does not indicate that the
system is powered on! Only the green POWER LED
indicates system power on/o status.
♦ Red HDD LED: lit when there is hard disk activ-
ity.
You will notice that the main screen’s backlight will
come on when power is applied. After a few mo-
ments the BIOS and Windows operating system
messages and graphics will appear.
⇒ If the system does not power on, ensure that you
have batteries with at least 30% charge, or that the
DPS-2410 is properly connected and TURNED ON.
Hardware Protocols
Using the removable hard disk drive
The right side of the DEWE-321x has a 2.5” remov-
able drive bay. This single bay has two separate
hard drives inside it: a C drive for Windows and ap-
plications, and a D drive for data.
⇒ If this is the only hard drive in the system, do NOT
remove it when the system is powered on! This will
cause Windows to crash very badly. If you have an
internal hard drive which has the Windows operat-
ing system, then removing the external drive is
permitted when power is on, because you are not
writing to it at that time.
To remove the hard drive, you must have access
to the keylock. Turn the key into the lock and then
The DEWE-321x power switch is a momentary type, located
on the front panel near the LED battery status display. To its
right are LEDs for system power (green) and HDD activity
(red).
The DEWE-321x right side panel contains the removable
HDD and the optical media drive as standard.