Specifications

5-92 | OWNER’S GUIDE
CAN BUS interface connector (installed when you order CAN BUS option)
Connectors: LEMO EGG.1B.306.CLL
Mating connector: LEMO FGG.1B.306.CLL
Mating cable: CAN-CBL-Y
PIN Function Comment
1 CAN0 Lo First CAN port
2 CAN0 Hi First CAN port
3 D GND
4 CAN1 Lo Second CAN port
5 CAN1 Hi Second CAN port
6 GND
Function: used to connect to vehicle CAN BUS interfaces. Also can be used to read data from sensors which
have a CAN BUS output, such as Dewetron’s own CPAD2 series signal conditioning modules.
When the CAN option is installed, this single LEMO connector will contain two CAN BUS interfaces. The
CAN-CBL-Y mating cable is optionally available to split the single LEMO connector to two standard CAN
DB-9 (female) connectors. Both DB-9 connectors are wired the same way, as shown below:
When you connect either CAN bus interface to your vehicle or other CAN network, it is necessary to add
termination resistors (not included) at each end of the cable:
- Note: this connector does not provide power for CPAD2 series modules.