Specifications

4-72 | OWNER’S GUIDE
Operation Guidelines
System Startup Protocol
DC powered systems (STANDARD)
The standard D3PC runs from wide-ranging DC
power: 9-29 VDC. An AC/DC adapter is included
with your system.
To run the system from AC, connect the AC power
cord to AC mains and to the AC/DC adapter. Con-
nect the DC output cable that has a round LEMO
connector on it to the DC power input on the rear
panel of the D3PC.
Connect a display
Please connect a standard VGA or XGA monitor to
the VGA connector on the rear of the system, behind
the computer protection door.
Turning on the System
Ensure that the master power switch on the REAR
panel is in the ON position, then press and quickly
release the soft power switch on the FRONT of the
D3PC, and the system will boot up.
♦ Press ON and hold for one second to power the
system on.
♦ Press ON and hold for 3 seconds to power OFF.
Front Panel LED indicators
♦ Green POWER LED: Indicates that power is on,
when lit
♦ Red HDD LED: indicates hard disk activity, when
lit / ashing
The D3PC MASTER power switch is located on the REAR
panel, directly above the 9-29 VDC power input connector.
The D3PC SOFT power switch is located on the FRONT
panel. Adjacent are LEDs for system power (green) and HDD
activity (red).