Specifications
OWNER’S GUIDE D3PC8 | 469
Counter/encoder connectors (2)
Connector: LEMO EGG.1B.307CLAD52
Mating connector: LEMO FGG.1B.307CLAD52
Mating cable available: CTR-CABLE-05 (includes connector)
Function: used to input tachometer, TTL level pulse train, or encoder outputs for measuring and conversion.
- Note: see the COUNTER conguration section later in this guide.
CAN BUS interface connector (installed when you order CAN BUS option)
Connectors: DSUB 9 connectors (option UP-ORION-CAN2)
Mating connector: DSUB 9
Mating cable: Standard CAN cable
Function: used to connect to vehicle CAN BUS interfaces. Also can be used to read data from sensors which
have a CAN BUS output, such as Dewetron’s own CPAD2 series signal conditioning modules.
The typical DB-9 connectors are wired the same way, as shown below:
When you connect either CAN bus interface to your vehicle or other CAN network, it is necessary to add
termination resistors (not included) at each end of the cable: