Specifications
OWNER’S GUIDE D3PC8 | 457
Connecting a Standard VGA/XGA Monitor to your D3PC-8
The D3PC-8 accepts any standard computer monitor that can be plugged into the standard VGA connector
on the rear of the system. Open the computer door by turning the captive spring-loaded thumbscrew hard-
ware counter-clockwise, until the door opens.
The VGA connector is the ‘D’ connector with three rows of pin holes. This connector is normally located in
the bottom left corner of the computer area.
Connect your monitor and turn on the D3PC-8. The Windows operating system should recognize that a
monitor has been connected and utilize it. After the system is booted up into Windows you can use the stan-
dard commands to congure the monitor the way that you prefer. We recommend setting the resolution to
1024 x 768 pixels for best performance within the software. However, you can also set it higher, for example,
to 1280 x 1024 pixels. This should also provide excellent performance.
D3PC with a standard computer monitor connected to it. Use a standard VGA cable to make
the connection. The monitor must be powered separately from VAC mains.