Specifications

18-440 | OWNER’S GUIDE
The button “NMEA log” shows/hides the raw NMEA data stream from the GPS receiver.
Measurement setup
When the DEWE-CLOCK is used as timing device and you switch to the measurement screen you will see
the actual time from the DEWE-CLOCK shown in the top right corner of the screen. A green dot next to this
time indicates that the DEWE-CLOCK is locked to the GPS or IRIG time whereas a red dot indicates that the
DEWE-CLOCK is in free-run mode.
As default the local time is stored inside the data le. But if the measurement results from multiple systems
located in different time zones should be analyzed it is recommended to set to UTC or GPS time. This can
be done in the Global settings of DEWESoft (Settings Global settings Displays). Doing so, the data from all
data acquisition systems are containing the same absolute time stamp.