Specifications
OWNER’S GUIDE CONDITIONERS, MDAQ | 15379
15
MDAQ Series Conditioners
MDAQ Series Common Information
Calibration information
All DEWETRON modules are calibrated at 25°C after a warmup time of 30 minutes and meet their speci-
cations when leaving the factory. The time interval for recalibration depends on environmental conditions.
Typically, the calibration should be checked once a year.
Calibration certicates are available from DEWETRON as an option. DEWETRON offers several types:
NIST traceable DEWETRON calibration certicate (USA CAL LAB only)
ISO traceable DEWETRON certicate (European CAL LAB only)
Calibration certicate according to ÖKD (equivalent to DKD)
This manual contains no calibration information. There are separate resources optionally available for
MDAQ series modules for automated calibration under Met/CAL®. The CAL-KIT contains the required
cables, software and instructions that you need to add to your own calibration lab. It does not include a
calibrator or volt meter.
General MDAQ module specications
MDAQ modules are factory installed within your Dewetron system. From the outside you see only the input
connectors. But inside, there is a BASE card which can hold any two 8-channel MDAQ-SUB modules on
one side, and any MDAQ-FILT lter card on the other side. The result is a system which can be congured
to suit a wide variety of applications.
All specications within this manual are valid at 25 °C.
All modules are produced according to ISO9001 and ISO14001.