Specifications
OWNER’S GUIDE CONDITIONERS, PAD | 14369
And your choices are:
If you have plugged a new module into this slot, choose FILL, then follow the prompts.
If you change you mind and want to do a FILL RACK anyway, starting at slot 0, choose FILL FROM #0,
then follow the prompts.
If there is a module in this slot that you have removed, but it continues to show up in RED (because the
software cannot really nd it), choose CLEAR to remove it from the list.
If you have clicked this by accident and want to cancel without making any changes, choose CANCEL
Module Installation Trouble-shooting
There may be times when you have trouble addressing your modules, for a variety of reasons. Here are
some good tips for solving these issues:
⇒ Problem: Some or all modules are showing up in RED letters.
Analysis: a module shown in RED letters on the setup screen tells you that the software cannot nd this
module. Or, it can mean that there is a conict with another module, like when you plug two modules with
the same address into the system at the same time and don’t do a FILL RACK or FILL (or CLEAR) one of
them. A very rare condition might be that a module is defective and cannot communicate properly.
- Solution: the FILL RACK procedure is always a great and easy way to solve nearly all these issues. If the FILL RACK
does not solve them, remove any modules shown in RED and add them back in one at a time, using the FILL
ONE MODULE procedure. Fill one module at a time until the oending modules’ addresses have been resolved.
⇒ Problem: you plug in a new module into a previously unused slot, but it does not show up.
Analysis: more than likely it was already set to an address that you were using, and it has either taken an-
other module’s address, or is conicting with it.
- Solution: the FILL RACK is always a great and easy way to solve nearly all these issues. If the FILL RACK does not
solve them, remove any modules shown in RED and add them back in one at a time, using the FILL ONE MOD-
ULE procedure. Fill one module at a time until the oending modules’ addresses have been resolved.
⇒ Problem: you want to use a very old PAD module which does not have the upper black button on it, so you don’t