Specifications

13-322 | OWNER’S GUIDE
DAQP-V Signal Hook-up
DAQP-V-B model with banana jacks
DAQP-V-BNC model with BNC connector
DAQP-V-D model with DSUB connector
DAQP-V-L model with LEMO connector
⇒ IMPORTANT: Always observe all safety protocols when handling live voltages!
⇒ Use pins 4, 5 and 9 only as NON-ISOLATED sensor supply voltages
⇒ If signals above 60 V may appear, don’t use the metal housing of SUBD connector
- For sensor hook-up guidance and shunt resistor information, please refer to the DAQP-LV module
(except that TEDS is not available on the DAQP-V module)
Hot: IN+
Shield: IN-
DAQP-V-L pin-outs
LEMO EGG.1B.307
Pin Description
1 IN +
2 IN -
3 +9 V sensor supply
4 -9 V sensor supply
5 GND
6 +12 V sensor supply
7
not connected
DAQP-V-D pin-outs
Standard 9-pin DSUB connector
Pin Description
1
Not connected
2 IN +
3
Not connected
4 GND (not isolated)
5 reserved for +9 V sensor supply
6 +12 V sensor supply (200 mA max.)
7 IN -
8 Not connected
9 reserved for -9 V sensor supply