Specifications

OWNER’S GUIDE  CONDITIONERS, DAQ | 13321
V
DAQP-V Isolated Low Voltage Module (50 kHz)
Input ranges: 6 ranges from ±10 mV to ±50 V
Bandwidth: 50 kHz
Isolation: 350 VDC (1 kVRMS with banana connector)
Signal connectors: -B: Safety banana sockets
-BNC: BNC connector
-D: 9-pin SUB-D connector
-L: 8-pin LEMO connector (option)
DAQP-V Specications
Parameter DAQP-V
Input ranges:
±10, ±100 mV, ±1, ±5, ±10, ±50 V
Range Selection: Push button or software
DC accuracy:
10 mV range
100 mV range
1 V to 50 V ranges
0.05 % of reading ±40 μV
0.05 % of reading ±100 μV
0.05 % of reading ±0.05 % of range
Input coupling: DC fixed
Gain linearity: Better than ±0.03%
Gain drift range: Typically 20 ppm/°K (max. 40 ppm/°K)
Input resistance: 1 MΩ (±0.1 %)
Bandwidth (-3 dB): 50 kHz (±1.5 dB @ f0)
Filters (low-pass): 10 Hz, 100 Hz, 1 kHz, 10 kHz (±1.5 dB @ f0)
Filter selection: Pushbutton or software command
Filter characteristics:
@ 0.01, 0.1, 1, 10 kHz
@ 50 kHz
Butterworth
40 dB / decade (12 dB / octave)
100 dB / decade (30 dB / octave)
Typ. SNR @ max. bandwidth
10 mV range
10 V range
50 V range
61 dB
78 dB
78 dB
Typical CMRR:
90 dB @ 0 Hz
78 dB @ 50 Hz
60 dB @ 400 Hz
Isolation voltage: 350 VDC (1 kVRMS with banana connector)
Sensor supply: ±9 V (±1 %), 12 V (±5 %)
Output voltage: ±5 V
Output resistance: <10 Ω
maximum Output current: 5 mA
Output protection: Continuous short to ground
Power supply: ±9 VDC ± 1%
Power consumption: 0.85 W typical without sensor supply
RS-485 interface: Ye s
TEDS: N/A
Supported TEDS chips: N/A
Supported MSI N/A