Specifications

13-318 | OWNER’S GUIDE
Maximum Output current: 5 mA
Output protection: Short to ground for 10 sec.
Power On default settings Software programable
Power supply: ±9 VDC ± 1%
Power consumption: 0.8 W without sensor supply
RS-485 interface for module control: Yes
TEDS support: Yes, compatible with TEDS chips DS2406, DS2430A, DS2432, DS2433, DS2431
3)
MSI support: MSI-V-ACC; MSI-V-RTD; MSI-V-CHA-50
(1) 300 kHz exclusively for Bessel filter characteristic (2) Overall current should not exceed Dewetron mainframe’s maximum power.
(3) TEDS is only available on the -D and -L versions
DAQP-LV Signal Hook-up
DAQP-V-B model with banana jacks
DAQP-V-BNC model with BNC connector
DAQP-V-D model with DSUB connector
DAQP-V-L model with LEMO connector
⇒ IMPORTANT: Always observe all safety protocols when handling live voltages!
⇒ Use pins 4, 5 and 9 only as NON-ISOLATED sensor supply voltages
⇒ If signals above 60 V may appear, don’t use the metal housing of SUBD connector
DAQP-LV-D pin-outs
Standard 9-pin DSUB connector
Pin Description
1 TEDS
2 IN +
3 Reserved for custom sensor supplies
4 GND (not isolated)
5 +9 V (200 mA max.)
6 +12 V (200 mA max.)
7 IN -
8 Reserved for custom sensor supplies
9 -9 V (200 mA max.)
DAQP-LV-L pin-outs
LEMO EGG.1B.307
Pin Description
1 IN +
2 IN -
3 +9 V (200 mA max.)
4 -9 V (200 mA max.)
5 GND
6 +12 V (200 mA max.)
7 TEDS
Hot: IN+
Shield: IN-
See table >
Hot: IN+
Shield: IN-