Specifications

13-314 | OWNER’S GUIDE
Parameter DAQP-HV
Power On default settings: Software programable
RS485 interface for module control: Yes
TEDS support: N/A
MSI support: N/A
1) The 300 kHz filter setting applies only to the Bessell filter type
Signal hook-up
DAQP-HV: The insulated banana jacks are the signal connection point. Use only mating cables which have
molded insulated/safety type plugs. These plugs should be the kind which prevent you from coming into
contact with high voltages or currents.
DAQP-HV-S3: The insulated screw terminal panels are the signal connection point. Always make your con-
nections before applying voltage to them.
⇒ Use only insulated cables and the appropriate mating plugs or connectors when using this module!
⇒ Never handle cables when high voltage is applied! Connect your signal points before applying high voltage!
⇒ Failure to observe safety protocols can result in equipment damage, and personal injury or even death!
⇒ Always check that positive and negative lines are connected with the correct polarity on the DAQP-HV and
DAQP-HV-S3 module, and at the signal source side.
⇒ Use of red (+) and black (-) color coded cables is highly recommended.
⇒ High voltages can be lethal! Observe all safety protocols at all times.