Specifications

13-310 | OWNER’S GUIDE
Follow the instruction to press the TOP black button on the module in the rst slot, which is always SLOT 0
in the case of doing a FILL RACK, since you are starting at 0 and going all the way up, lling all modules.
When you press this button on the module, the system will beep and prompt you to press the next module’s
button, and so on. Continue all the way through until you have done the last module, then press CANCEL to
complete and save your changes.
If you get to the position where there is an empty module slot, or a non-programmable module from the old
days in that slot, press the SKIP button to move past it to the next module. You can do this as many times as
needed.
When you’re done, the rack should be lled with all of the modules that are physically installed within this
system, like this:
FILL (or CLEAR) One Module Procedure
FILL RACK is a great way to ensure that your modules are all addressed correctly, and we highly recom-
mend it if you make several module exchanges at once. But there are times when you simply want to
exchange one module with a different one, or perhaps to just remove a module. This is also quite easy once
you know how.
Within DEWESoft, go to the ACQUISITION MODE and select the SETUP screen, where you can see your
list of modules. This time, instead of clicking on the top of the AMPLIFIER COLUMN, double-click the ampli-
er column for the one module that you want to add, delete, or exchange. When you do this, the software
will give you a similar choice as before:
And your choices are: