Specifications
300 | OWNER’S GUIDE
HSI-STG Full bridge signal connection
6-wire and 4-wire sensor connection
Voltage or Current excitation are allowed.
Sense lines MUST be connected to the excitation also when 4-wire connection is used.
6-wire sensor connection: Sense+ is connected to EXC+ at the sensor
4-wire sensor connection: Sense+ is connected to EXC+ at the connector
HSI-STG Half bridge signal connection
5-wire and 3-wire sensor connection, and potentiometric sensors
5-wire sensor connection: Sense+ is connected to EXC+ at the sensor
3-wire sensor connection: Sense+ is connected to EXC+ at the connector
Voltage or Current excitation are allowed.
Sense lines MUST be connected to the excitation also when 4-wire connection is used. A potentiometer can
be seen similar to a half bridge sensor with ±500 mV/V sensitivity. Therefore potentiometric sensors can be
measured with bridge ampliers. The advantages of using the DAQP-STG for potentiometric measurements
is by adjusting the offset and range, you can focus on a certain potentiometer position with higher resolution.