Specifications
OWNER’S GUIDE SIGNAL/SENSOR ADAPTERS | 11281
Using the ADAP-BR-1/4-120 or 350 bridge completion adapters
These adapters are only needed for Dewetron bridge conditioners which do not have internal completion for
1/4 bridge sensors. Therefore they are not needed by the DAQP-STG, DAQP-BRIDGE-A, DAQP-BRIDGE-
A, or MDAQ-SUB-STG-D, because these all support full bridge, half bridge and quarter bridge with internal
completion for many bride wiring scenarios.
However, these adapters to apply to Dewetron conditioners that lack 1/4 bridge completion, including the
MDAQ-SUB-BRIDGE-D (which supports full and half bridge inputs only), as well as the inputs of the DEWE-
43, DEWE-101, and DEWE-3213 (those models support full bridge inputs only). Select the full bridge mode
of the MDAQ-SUB-BRIDGE, and then plug in the completion adapter.
This is less convenient than using a more capable signal conditioner, not only because of the external adapt-
er, but because you cannot use the balance buttons in this mode. But it serves to adapt this less capable
conditioner to handle 1/4 bridge sensors.