Specifications

11-280 | OWNER’S GUIDE
In this case we recommend that you leave the Measurement type to Voltage, and simply enter the appropri-
ate engineering units and scaling factor. For example, if you were using a current clamp that could measure
250 Amps, but which output 0.1 V/A, you would simply set up this channel like this:
After you set the Units to A, then enter the scaling factors as shown above so that 0.1 V = 1 A, simply use
the Range selector to choose the appropriate current measuring range. Keep an eye on the right side of the
scaling BAR in the bottom left corner of the screen. Notice that when you select the 25V measuring range,
you will get a full scale 250 A measuring range. This is perfect. You can select smaller ranges if you expect
that the current input will not really reach 250 A. Choose the range that best ts to your current sensor AND
the desired measuring range.