Specifications
OWNER’S GUIDE SIGNAL/SENSOR ADAPTERS | 11279
When you do this, the software allows you to enter the value of the shunt resistor that you are using, as well
as the maximum wattage. The software will do the appropriate Ω’s law calculations to amperage for you
automatically.
- Note - Dewetron conditioners such as the MDAQ-SUB-BRIDGE and MDAQ-SUB-STG also support the direct
selection of CURRENT as a measuring type. Therefore you can use them with shunts as shown above. You simply
need to adapt the input connector to handle a shunt resistor. An idea choice is the CONN-DSUB-9 mating con-
nector, which makes it easy to insert your own shunt resistor into the mating connector and plug it into the
DSUB 9-pin input connector of the module.
…Using Current sensors