Specifications
11-278 | OWNER’S GUIDE
For instance, if your 4 - 20 mA signal really represents -100 to 5000 PSI, you could enter these scaling val-
ues quite easily on this same screen. First change the Units from mA to PSI, then below in the Scaling area,
enter these values:
That’s all you would have to do! Any scaling parameters which are linear can be entered in this way.
- Note: the ranges shown above apply to the DAQP-LV module. When you use the DAQ-SHUNT-1 with other mod-
ules, the ranges will be dierent according to which module is being used.
Using custom Shunt resistors
After selecting CURRENT input type you can also select CUSTOM instead of one of the preset current
adapters, at the end of the list: